AMP TOPOLOGY – Monoblock, Class A/B
CHANNEL CONFIGURATION – 1 Channel
POWER SUPPLY TYPE – MOSFET Power Supply
TOTAL POWER OUTPUT – 1500 Watts
PEAK POWER @ 2 Ω – 1500 Watts x 1
RMS POWER @ 4 Ω – 563 Watts x 1
SPEAKER IMPEDANCE – 2-8 Ω
T.H.D. (TOTAL HARMONIC DISTORTION) – 0.01 %
S/N RATIO (A-WEIGHTED) – 103 dB
FREQUENCY RESPONSE – 9 Hz to 50 kHz ±1 dB
Connections, Controls, and Processing
RCA INPUTS – 2 Channel
HIGH LEVEL INPUTS
LOW PASS FILTER – 50 Hz to 250 Hz
HIGH-PASS FILTER – Variable 50 Hz Hz to 250 Hz
BASS BOOST – Variable to 18 dB
REMOTE SUBWOOFER CONTROL
INPUT SENSITIVITY SWITCH
Class A/B amplifiers have long been known for their ability to produce great quality sound while performing more efficiently than pure Class A amplifiers. We have developed a specific linear circuitry that further reduces distortion while increasing both sound quality and power output.
Subwoofer Level Control
The wired remote subwoofer level control, mountable for easy access, has long been a popular feature on many of our amplifiers. The remote allows you to control the output level of the subwoofer(s) as needed for optimum sound according to your personal taste and listening environment.
High and Low Level Inputs
High and Low Level Inputs
2 Ohm Stable
The lowest impedance accepted by this amplifier is 2 ohms. Amplifiers that are 2 ohms stable produce more power resulting in more volume. This amp can comfortably power speakers or subwoofers with all channel(s) being used at a load of 2 ohms.
Selectable LP Slope
A Selectable Low-Pass Slope on subwoofer amplifier is priceless; it allows you to choose between a 12dB or 24dB slope. As the slope dictates the rate at which the crossover cuts off, this feature provides another tool for you to fine tune your subwoofer system.
Switchable Input Sensitivity
Switchable Input Sensitivity gives you the freedom to connect the amp to any standard source unit and have peace of mind it will be within range to properly match the output of the source unit allowing you to use the volume controls on your source unit the way it was designed.
If the amplifier gets too hot, the thermal protection circuit turns the amp off and allows the amp to cool down before turning it back on. If a speaker fails causing an electrical short, the protection circuit will automatically cut the output and remain in that state until the short is resolved. These safety features give you peace of mind knowing the amplifier is constantly monitoring conditions to protect itself.
Wireless Remote Control
A wireless remote control gives you commanding access to the key functions of your unit from the palm of your hand.
If the model item you are looking for is not shown, please fill out “Product Enquiry” and we will respond.