AMP TOPOLOGY – Monoblock, Class D
CHANNEL CONFIGURATION – 1 Channel
POWER SUPPLY TYPE – MOSFET Power Supply
TOTAL POWER OUTPUT – 4000 Watts
PEAK POWER @ 1 Ω – 4000 Watts x 1
PEAK POWER @ 2 Ω – 2000 Watts x 1
RMS POWER @ 4 Ω – 750 Watts x 1
STRAPPED POWER BRIDGED @ 2 Ω – 8000 Watts
SPEAKER IMPEDANCE – 1-8 Ω
T.H.D. (TOTAL HARMONIC DISTORTION) – 0.01 %
S/N RATIO (A-WEIGHTED) – 100 dB
FREQUENCY RESPONSE – 15 Hz to 150 Hz ±1 dB
Connections, Controls, and Processing
RCA INPUTS – 2 Channel
PRE AMP OUTPUTS – 2 Channel
LOW PASS FILTER – 50 Hz to 150 Hz
SUBSONIC FILTER – 15 Hz to 40 Hz
BASS BOOST – Variable to 18 dB
PHASE CONTROL to 180°
REMOTE SUBWOOFER CONTROL
INPUT SENSITIVITY SWITCH
Class D Amps
Class D is a high speed switching amplifier technology that is more efficient, generates less heat and draws less power than traditional Class A/B amps. We use Class D in our monoblock amplifiers to give you massive amounts of power in a relatively small footprint for clean, powerful, bass.
Subwoofer Level Control
The wired remote subwoofer level control, mountable for easy access, has long been a popular feature on many of our amplifiers. The remote allows you to control the output level of the subwoofer(s) as needed for optimum sound according to your personal taste and listening environment.
1 Ohm Stable
The lowest impedance accepted by this amplifier is 1 ohm. Amplifiers that are 1 ohm stable produce the most power possible from the amp. An amplifier capable of delivering power at a 1 ohm load is usually reserved for serious subwoofers that can handle the power. Please note this particular amp needs a healthy electrical system including a low gauge wire capable of delivering the necessary current.
Strapping capability means that two amplifiers can be linked together to create double the power at an impedance of 2 ohms. A benefit of strapping is less electrical current is required than if you ran  individual amps at 1 ohm and you only need 1 pair of preamp outputs and  RCA cable to connect.
Selectable LP Slope
A Selectable Low-Pass Slope on subwoofer amplifier is priceless; it allows you to choose between a 12dB or 24dB slope. As the slope dictates the rate at which the crossover cuts off, this feature provides another tool for you to fine tune your subwoofer system.
Switchable Input Sensitivity
Switchable Input Sensitivity gives you the freedom to connect the amp to any standard source unit and have peace of mind it will be within range to properly match the output of the source unit allowing you to use the volume controls on your source unit the way it was designed.
If the amplifier gets too hot, the thermal protection circuit turns the amp off and allows the amp to cool down before turning it back on. If a speaker fails causing an electrical short, the protection circuit will automatically cut the output and remain in that state until the short is resolved. These safety features give you peace of mind knowing the amplifier is constantly monitoring conditions to protect itself.
Wireless Remote Control
A wireless remote control gives you commanding access to the key functions of your unit from the palm of your hand.
If the model item you are looking for is not shown, please fill out “Product Enquiry” and we will respond.